NOTES FROM THE BENCH
Clock Repair Archive - - Strike hammer support spring:
The modern german floor clock mechanism strike hammer support spring on the grandfather
clock mechanisms is .0075 inches thick and .200 inches wide.
Back to Notes From The Bench index
Page by: Perpetual PC's
Copyright (c) 2002 David Tarsi.
Permission is granted to copy, distribute and/or modify this document
under the terms of the GNU Free Documentation License, Version 1.1
or any later version published by the Free Software Foundation;
with the Invariant Sections being no invariant sections, with the
Front-Cover Texts being no Front-Cover Texts, and with the Back-Cover Texts being
no Back-Cover Texts.
A copy of the license is included in the section entitled "GNU
Free Documentation License".
The content of this website and journal
has been prepared to provide information on the authors experience.
The information is not a complete source.
Use at your own risk. Any advice given by the author also is covered by this
statement. This website and journal is not endorsed by any manufacturers mentioned.
This website and journal has no connection whatsoever to any of the manufacturers mentioned.
Your use of this information and your use of any advice given by the author
is your acceptance of responsibility for all consequenses resulting in such use.
No legal liability attaches to the author, the website, or the isp for any inaccurate
or misleading information contained on the website and journal at any time or for the consequences
of any errors or omissions or for the use of said information. However if written
notice is given to the webmaster of inaccuracies or omissions, the author will endeavor
to establish the factual position and where necessary correct
the content of the website and journal in an appropriate and timely manner.